Jump to content

After editing and saving a .nif file in Nifskope, the changes don't show up in the GECK.


CountYum

Recommended Posts

I've been trying to edit some armor for Fallout: New Vegas, and after I make the changes, save it, and load it in the GECK, the added parts of other armors don't show up on the rendering. I can open the saved .nif file and the changes are still there, so I know it saved properly, but it just won't show up in the GECK. The pictures below show the file open in Nifskope and the GECK.

 

(Sorry I had to upload them to imgur, whenever I tried to attach a file here it said the upload failed.)

 

Here it is loaded in Nifskope:

 

http://imgur.com/mrP8mxJ

 

 

And here it is loaded in the GECK:

 

http://imgur.com/GtrUlZn

 

 

Does anyone know how I can get the added parts to show up?

Link to comment
Share on other sites

Make sure the flag SF_SKINNED is set in your added parts. (Look at the Shader Property)

Thanks for the reply, and excuse me if this is a really stupid question, but where can I set the SF_SKINNED flag? I looked in (what I think is) the Shader Property, but couldn't find the flag.

 

 

EDIT: Ignore the crossed out part, I found it. It has the checkmark in the box already, and I'm assuming that means it is set, but it still doesn't work. Thanks for the help, though.

Edited by CountYum
Link to comment
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...