Note: The primary thread for data, discussion, and suggestions can be found here (skyrim.reddit.com). While I will respond in this thread from time to time, it will be FAR easier for me to maintain a conversation/collect data in one place than two. Over the past twelve hours I have been running comparison screenshots of twelve different post process injectors that are commonly used by modders. Initially, this was so I could make an informed choice on my own but after collecting the vast quantity of data I felt it was only proper to share it with the community at large. I have used 13 different screenshot locations (Test 12 & 13 has changed since original submission) along with an Autohotkey macro to obtain uniform timing inbetween screenshots and processors. I've also used 'tai' and 'tm' to minimize NPC/UI clutter for an easier visual reference. The tests were performed on a default Skyrim on Ultra settings with Skyrim High Resolution DLC, and the bEnableFileSelection=1 as required in SkyrimPrefs.ini for most Post Processors. I was unable to measure the performance impact due to my hardware outpacing the software and thus I encourage you to find the injector you enjoy the most and testing it for accurate performance results. If you have questions I'll answer them for as long as I'm awake and continue upon (my) morning. Enjoy, and cheers. I'd like to thank all of the authors that contacted me to resolve bug issues so that their mods could be properly displayed. Finally, now that I have a scripted, simplistic process to create additional screenshots... if you'd like a specific injector added please let me know. tl;dr: Sometimes showering with a troll leads to bruising the hippocampus. Please see the original article for all of the testing results, discussion, and suggestion: here (skyrim.reddit.com)