Jump to content

Nordic Ruins - Quick question about ceilings.


Stammetje91

Recommended Posts

Hiya,

 

I am kinda new to level design in Skyrim, and ran into a little problem today. At the moment I am busy with a Nordic dungeon, which includes a shaft going up into a small room (using mostly the Static > Dungeons > Nordic > SmRooms tiles). However, it occured to me that there are no ceiling-only tiles in this category to fill up the void above the shaft. I have tried using the NorRmBgMidCeilingOnlyLow01 from the BgRooms category, but these do (1) not use the same grid to snap to (using a snap-to-grid value of 128) and (2) when manually trying to fit them into the ceiling they either leave a little space in between tiles (when leaving them the standard size) or overlap with the walls to the side or one another (when enlarged one tick).

 

My question to you is whether there is a way to add in a ceiling-only tile above such a shaft. I will try to add some pictures in the coming ten minutes.

 

Kind regards,

 

Stammetje91

 

Edit: Pictures added. Help01 shows the situation I tried to describe, whereas Help02 shows what the problem is in-game (as well as in the Creation kit when you zoom in). Sorry for the low quality pictures, the forum limits file size of attachments severely.

 

Edit2: I got it to work by manually incrementing the Z-values of the ceiling bit by bit. There should be an easier way to do this though. Apparently the seams where caused by the ceiling hanging a little lower than the rest, instead of a difference in tile size.

Edited by Stammetje91
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...