metaton Posted October 17, 2014 Share Posted October 17, 2014 Hello, I just made a completely new setup, and it is running smoothly with 200 mods installed, no problems so far, all the utilites are installed, like SSME, stableUgridtoload, SKSE 1.7 (memory allocation patch not implemented, did not work, this is why I use SSME ), safety load(configured to not to work just when loading.)etc. My only problem is that I get occasional CTDs when I enter a new area, for example I got CTD when I entered riften from outside, same happened with Whiterun as well.Riften was `clean` unmodded at this time. However I won`t get CTD always, most of the time I can enter without problems, let just say once from 15-20 loads I get CTD. This is not occurs when I loading up saves!So this is not a typical savegame corruption issue. Also because my game is quite fresh, these are new saves anyway. It is also really hard to pinpoint what is causing it, because it is happening occasionally. Any ideas what could be wrong? Link to comment Share on other sites More sharing options...
Donatoo Posted October 17, 2014 Share Posted October 17, 2014 What did you set your uGridsToLoad at? Link to comment Share on other sites More sharing options...
metaton Posted October 17, 2014 Author Share Posted October 17, 2014 (edited) I did not changed the Ugrid settings (it is on default value, I have been there done that..not again...)and I haven`t set it to anything. Just using the cellstabilizer.dll file.The reason why is: premiumGlanzer11 kudos1211 postsI've used this mod with ugrids set to 5 with no problems. I read several places that this mod helps even if you don't change ugrids and that's why I've used it. I have a VERY stable skyrim and I have many mods (315 mods, 248 plugins).reportposted @ 16:13, 14 Sep 2014ReplypremiumRichardPellets11 kudos610 postsYup, this mod helps for sure = ) even with 5 In safety load settings I set onload=true Edited October 17, 2014 by metaton Link to comment Share on other sites More sharing options...
Recommended Posts