Jump to content

4GB Patch installed but still get low memory error ?!


HyperGenz

Recommended Posts

4GB Patch installed but still get low memory error....


I have 167 mods, NVAC, NVSR, 4GB patch properly installed so don't ask, no ENB, One Tweak, YUP mod, Mission Mojave patch...


I also set these within Fallout.ini, FalloutPrefs.ini, Falloutdefault.ini with this command bSelectivePurgeUnusedOnFastTravel=1 bPreemptivelyUnloadCells=1, Which helped for a while then started again with low on memory... The values are still set and they did not reset...


1. I also tried many settings with virtual memory under system settings and same result,

2. Tried setting the game to run as XP SP3 and admin and same result,

3. Tried settings these under all three ini files but same result, even tried setting HW thread to #2 still same, bUseThreadedAI=1 iNumHWThreads=4

4. Tried disabling that option under Group policy's still same result


Am always at 60 frames, I never stutter, micro stutter or Crash, but when i do its because of that error "Low on memory"

All four cores are not parked, I do not have any large background task running, No AV scans in background either, only thing that's open is discord... Fallout new Vegas is the only app that has this issue

I have Windows 10 Enterprise 64bit...



There is just one mod that could be the problem....

I have IWS interior and exterior spawns. Means more enemy's will spawn in every location, indoors and out, even triggered points as well... I have all the IWS settings maxed out for best experience..


My PC specs are this

AMD FX-4300 4 Cores 3.8Ghz

AMD RX-550 4GB Vram

8GB DDr3 1600Mhz

3 TB drives at 7500rpm

1 SSD

500w PSU

Link to comment
Share on other sites

There is more than one cause of "out of memory" errors. The 4GB patch works. If it isn't for you, then either you failed to apply it correctly (unlikely, I know), or this is related to something else. Unless you are using a shortcut to specifically launch NVSE, it should be automatically run by the patched FalloutNV.exe. Check in the game root folder (where FalloutNV.exe is found) for the "nvse_steam_loader.log" (assuming you aren't playing the GOG version. If you are, there should be some equivalent). Examine that for any error reports.

 

As you have "New Vegas Stutter Remover" (NVSR) installed, please see the 'Issue: CTD after 10-20 minutes of play (post-Win10 2017 FCU)' and 'Issue: CTD without warning, "Out of Memory error", or stops responding after the Main Menu' entries in the 'Solutions to "Crash To Desktop" (CTD) problems' section in the wiki "Fallout NV Mod Conflict Troubleshooting" guide.

Anytime the game "Crashes to the Desktop" (CTD) it's typically going to generate an error message in the Windows Eventlog. Please see the "Windows Error Messages" section of the wiki "How to read most Bethesda game error logs" article.

-Dubious-

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...