South8028 Posted September 2, 2021 Share Posted September 2, 2021 (edited) Where can I find complete documentation on ini file's parameters? I have disabled wetting, overlapping from shots. How do I enable them? Also, in the previous version, before the update to 1.10.163, the drawing range was three times higher than now. Is there a way to remove the rendering of precombined meshes altogether? So that the map is always fully loaded within sight ... Edited September 2, 2021 by South8028 Link to comment Share on other sites More sharing options...
RoNin1971 Posted September 2, 2021 Share Posted September 2, 2021 Guide:Fallout4Prefs INI: https://stepmodifications.org/wiki/Guide:Fallout4Prefs_INI That one is pretty extensive in documenting all options and explaining them, if possible. Link to comment Share on other sites More sharing options...
South8028 Posted September 2, 2021 Author Share Posted September 2, 2021 Guide:Fallout4Prefs INI: https://stepmodifications.org/wiki/Guide:Fallout4Prefs_INIÂ That one is pretty extensive in documenting all options and explaining them, if possible.Thanks. It turns out that I had devils in the settings. ) Half of the parameters are twisted to insane numbers, half are off. In general, it is not clear how everything worked. ) Link to comment Share on other sites More sharing options...
Recommended Posts