wfandrews Posted March 29 Posted March 29 I got SSELODGen working finally, ran SSELODGen64.exe and it ran perfectly as far as I could tell. The problem occurred when I ran it with the tree LODs enabled and without the Tree LOD enabled. When I started a new game I had reinstalled SSE AE GOG version 1.6.1179.0 so this was a completely new game. The mods I had installed and activated at the start of this game were; USSEP, Address Library for SKSE plugins. Main Font Replacement,More Cursory Cursor, SkyUI_2_SE, SkyUI_5_2_SE Plugin with Master added, MCM Helper, powerofthree Tweaks, SSE Engine Fixes and Unofficial Skyrim Creation Club Patches. Most of these do not have an esp or esm. I ran LOOT reset Archive Invalidation ran SSEEdit, restarted my computer and commenced to play. As usual I played through the intro until I emerged from the cave and then made a couple of saves. Then I ran SSELODGen64.exe and started my game from skse64_2_02_06_gog loader shortcut. When I went to Load my save I got a CTD. I could not load a save, as I only had the mods I mentioned installed and activated I do not have a clue as to what the problem is. Most of the problems I have been having with SSELODGen are my own fault but I can not figure out what could be wrong with this. I am about to give up on this mod. If anyone can pinpoint a problem I would appreciate it.
7531Leonidas Posted March 29 Posted March 29 2 hours ago, wfandrews said: As usual I played through the intro until I emerged from the cave and then made a couple of saves. If you ran LODGen and loaded a save when outdoors, it could cause problems. I know that it does with DynDOLOD. Make sure that you are indoors before running/updating LOD. I hope that it helps.
wfandrews Posted March 30 Author Posted March 30 (edited) I ran SSELODGen after emerging from the cave. I will try to run it before I leave the cave. I wish I knew how to uninstall that mod. I usually save three times after emerging then cut and paste saves 2 and 3 and copy save 1 to an SSE Saves folder. When I try a new save before running LOD I still am unable to load the game so I must reinstall my game. You could be right about that. I run xLODGen with both Fallout 3 and FNV with no problem. I run them both from an inside cell though. FNV from Doc Mitchell's house and Fallout 3 from the entrance to the vault before I exit for the last time after finalizing my settings. I went into the traders in Riverwood and ran SSELODGen and it ran correctly. Unfortunately when I exited the store I got a CTD and if I tried to load a save in any outside cell it would not load. Any ideas? Edited March 30 by wfandrews 2nd thoughts Failure
Recommended Posts