sheldrine Posted November 19, 2009 Share Posted November 19, 2009 I have installed a full list of mods, and tweaked (and tweaked) the load order until everything mostly works. I have encountered a couple very minor problems with landscape, however. Here and there I run into a situation where the landscape outside seems to tear. It is like there is one mod placing a piece of land in one spot and a vertical gap to the land below. In a few places it is big enough to walk through -- doing so has you 'fall' to the land above you. Is there an easy was to fix this problem in the toolset? I don't think I can do much more with my load order without Oblivion getting so fed up with me that it uninstalls itself from my hard drive out of spite. Is there a tutorial that will show me how to get in and quickly move a dozen places a couple of feet? Thanks in advance for your help. Link to comment Share on other sites More sharing options...
Megatarius Posted November 19, 2009 Share Posted November 19, 2009 What's your load order? Are you running Unique Landscapes and OOO? I ran into this same problem with IC Island Unique Landscape and OOO. You need UL lower than OOO. At least that's how I fixed my problem. I later ran into a cell-sized hole in the ground in the meadow east of the lake. You could jump right into LOD hell and all the rocks were floating over it. Link to comment Share on other sites More sharing options...
sheldrine Posted November 20, 2009 Author Share Posted November 20, 2009 Megatarius Over half the problems are around the fighter's stronghold. I do have Chorrol UL, but the gaps exist whether the Stronghold is above or below UL in the load order. Link to comment Share on other sites More sharing options...
Megatarius Posted November 20, 2009 Share Posted November 20, 2009 I"m not familiar with the Fighter's Stronghold. That's official DLC right? I take it it's near Chorrol then? Well, the only thing I would guess at this time is that Chorrol UL just isn't compatible with Fighter's Stronghold. Each was designed without the other in mind. Load order sometimes helps by forcing a correction, but only if there's an actual conflict. This just sounds like Fighter's Stronghold was designed for the regular land in the surrounding cells, but oops! UL alters that surrounding land. If you disable one and test it out, and then re-enable it and disable the other, are there still gaps? And each time, is the land there a different height? No actual "move a few places a dozen feet" tutorials, but there are lots of general land tutorials. If you follow them, whether they're relevant or not, you'll gain the knowledge pretty quickly I'd imagine. Good luck! http://cs.elderscrolls.com/constwiki/index...ing_and_Editing Link to comment Share on other sites More sharing options...
Recommended Posts