Domascus Posted November 21, 2009 Share Posted November 21, 2009 Hi, I have been playing Oblivion for a long time, and as you might expect, I have a lot of mods. I stopped playing Oblivion a few months ago, and just recently started again. My game is running fine when I use my old mods, however, when I install a new mod, I can't get past the title screen. When the screen says "Bethesda A Zenimax Company", the game just exits. I have tried adding several mods, and I always get the same result, so it isn't just one mod. I use OBMM to manage my mods, the latest version of OBSE to run the game, and most importantly, I'm running over 100 mods currently. I have already considered disabling my most recent mods to see if that was causing the problem, but I can't remember which one is the most recent (As I said I haven't played in a long time). Any help, tips or advice about my predicament would be greatly appreciated. Link to comment Share on other sites More sharing options...
dezdimona Posted November 21, 2009 Share Posted November 21, 2009 if you use OBSE you must launch the game using it,are you?do you have the latest patch installed?also what is your load order? Link to comment Share on other sites More sharing options...
Sarya Posted November 21, 2009 Share Posted November 21, 2009 Just how many mods? You can't have more than 255 .esps and .esms, not counting Oblivion.esm. Link to comment Share on other sites More sharing options...
Domascus Posted November 24, 2009 Author Share Posted November 24, 2009 I found the problem. All I did was show my mods in load order in OBMM, and disabled the most recent mod added. I'm not sure if that's how it is supposed to be done, but it worked for me. You would think after playing this game for 2 years I would have figured these kinds of things on my own. Anyway, thanks for your tips. :thumbsup: Link to comment Share on other sites More sharing options...
Recommended Posts