ineedanamethatworks Posted December 28, 2009 Share Posted December 28, 2009 I know I have been on alot lately but I just started but I need a problem figured out I just downloaded all DLC from the second disk and that was a pain in my ass but I got it on (my pc runs vista) and at the end I had to turn off the UAC and install it then I cut the UAC back on but the FOMM will not read that I have the DLC just my two mods and when I start fallout 3 launcher I went to data files and my DLC were on it but not my mods so what do I do? My question in short. I can't activate my DLC in FOMM and in Fallout 3 launcher in data files I can't activate my mods. So what do I do? I am just htting my head on wall at this point. :wallbash: Thank you all. Link to comment Share on other sites More sharing options...
joey2176 Posted December 29, 2009 Share Posted December 29, 2009 You need to make sure FOMM is installed to your Fallout3 folder, and your DLC's (esm's),mod files are located in your data foler. Link to comment Share on other sites More sharing options...
ineedanamethatworks Posted December 29, 2009 Author Share Posted December 29, 2009 ok they are not do you know where the DLC files are located i searched in the start menu DLC and all i got was DLC list and all it was is a notepad with Pitt.esm , brokensteel.esm , ect. typed up on it. So if i can not find it i will just re-install it and it will tell me where it is.One of the problems is that i have the dreaded Vista so that is the bad part lol. THANK YOU. YOU ARE A SAINT YOU DESERVE A THOUSAND COOKIES! srry about caps :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: :thanks: Link to comment Share on other sites More sharing options...
Recommended Posts