Can't find TSpaceFlag in NifSkope

[LittleNyx]

I'm trying to port some hair into New Vegas and I've reached the "Adjust the hair mesh in Nifskope" stage of this tutorial without too much trouble, but for some reason I can't seem to find "TSpaceFlag" in the Block Details of "NiTriShapeData". I've tried loading some meshes that have already been ported (e.g. a few of Ren's hairs) and looking for TSpaceFlag, but it doesn't appear then either.

 

 

It's probably right under my nose, but I can't figure out what's going on.

 

Thanks in advance!

Edited August 4, 2014 by LittleNyx

[JnazDgameR]

I know I cant seem to find it as well... :(

[Cameron71]

I found an example of where it should be but not anything else. My Nifscope also doesn't have it.

 

 

http://i722.photobucket.com/albums/ww221/BarneyMacau/Nif20091027-08.jpg

[Cameron71]

(From http://www.nexusmods.com/fallout3/Images/40602/?)

("Voodoo McGee 6 kudos115 posts)

(If you are using latest version of nifskope that property is no longer exposed in the UI so I guess skip that part of the tutorial. Based on your image you are lookinfg in the right spot, NiTriShapeData. I did verify that version 1.0.22 does expose and allow edit of this property but the latest 1.1.13 does not, you would have to ask the devs on the why part.")

edit; It may be necessary to down load an older version of nifscope to address the tspace flag change and then re upload the new version. I'm going to try to find it in blender first.

edit; I downloaded nifscope 1.0.22 and sure enough tspace is exactly where it's supposed to be. The tspace was also set at 16 straight out of blender.