OMEGADRACE Posted January 29, 2011 Share Posted January 29, 2011 Ok, not sure if this is the right forum or no but here we go. I'm trying to make a new worldspace using the tutorial on the wiki, and I'm stuck with the heightmap part. It's not that it's difficult, it is just that if I save once and then load it, the heightmap itself is gone. If I do it again then and save it twice, I get a "failed to load landscape data for LAND" error. Can anyone help me out here? Link to comment Share on other sites More sharing options...
OMEGADRACE Posted January 30, 2011 Author Share Posted January 30, 2011 I have found that when doing the fractal terrain tutorial on TESCS wiki, it crashes with a send or do not send error when importing the raw into the heightmap editor. Link to comment Share on other sites More sharing options...
OMEGADRACE Posted February 2, 2011 Author Share Posted February 2, 2011 Anybody? Link to comment Share on other sites More sharing options...
OMEGADRACE Posted February 4, 2011 Author Share Posted February 4, 2011 (edited) Well I think I've figured it out; It turns out my landscape wasn't high enough, even though the I did it to the tutorial's proportions. Actually, no. I don't get any errors when I make the map at a higher point, instead it still isn't saving properly. Thank you everyone who has helped so far. :rolleyes: Edited February 4, 2011 by OMEGADRACE Link to comment Share on other sites More sharing options...
Recommended Posts