Biohazard186 Posted December 19, 2015 Share Posted December 19, 2015 It's really becoming quite the pain in the ass. Like right now, I'm laying down the wooden foundation for a new building but I decide it would be best to make it with a second story so I remove one of the floor panels to put in stairs. After doing so I decide it would work best if I move the stairs to the next panel instead so I put the stairs in the workshop and attempt to move the floor panel. It will not snap. Or, to be more accurate, it does snap but it retains a red border so I can't put it down. But it gets weirder. If I rotate it I'll find one side will snap in perfectly fine and allow me to place it. The thing is a perfect square, what makes that one corner so special?! And naturally the one way it wants to fit in happens to go against the direction I have the boards running... Anyone else run into this nonsense and, better yet, know how I can fix it? Link to comment Share on other sites More sharing options...
cjoshuav Posted December 19, 2015 Share Posted December 19, 2015 I sometimes fit in different floor pieces temporarily, or put in a pre-fab cube temporarily, let it snap to that, take out the temporary piece, and put in what i had previously. Link to comment Share on other sites More sharing options...
Recommended Posts