montana38 Posted September 11, 2016 Share Posted September 11, 2016 Have just recently encountered this problem with my atrium end pieces {including the prefab pieces} and have no clue on how to fix it. My ceilings are still normal {using a modded in the screenshot but vanilla ceilings are good too} but for some reason the end pieces are almost cut in half at the sides leaving this awful gap. Been using mods in my game since day one with vault tec workshop, no problems. Started building a vault the other day and it was just changed to this. Tried starting a new game, and loaded up an older save in a complete vault as well but still had this problem. Tried to disable mods, as well as reinstall the vault tec workshop - still a problem. Wondering if anyone ever encountered something like this before and might know of a cause/fix. Thanks in advance! Link to comment Share on other sites More sharing options...
aWhatsit Posted November 11, 2016 Share Posted November 11, 2016 (edited) Same exact issue, cannot find anything about this other then your post. Did you ever find a fix? Edited November 11, 2016 by wjmonsey Link to comment Share on other sites More sharing options...
kitcat81 Posted November 11, 2016 Share Posted November 11, 2016 Disabling mods is not always a good way. Some mods require a special way of deinstallation and disabling them in NMM can cause glitches. I`d start with uninstalling mods that have something to do with the DLC, textures and building settlements to see if it helps. Uninstalling, not disabling.In the worst case you can always run a cache check in steam(verify integrity of game cache ). It fixes pretty everything, but it`s better to uninstall all your mods before doing this. Link to comment Share on other sites More sharing options...
Recommended Posts