Nitefox98 Posted December 7, 2011 Share Posted December 7, 2011 So on my most recent game install, I installed Qarls -> RAEVWD -> Enhanced Water, but then tried going back to the reduced lite Qarl's to see if it helped framerate at all, didn't notice much of an improvement, so reinstalled full Qarl's and RAEVWD again. Unfortunately, I must have screwed something up because the water reflections of the main bridge outside of the Imperial city appears correct from a distance (darker version of the bridge from RAEVWD), but flickers the lighter texture in certain spots when you get closer. Where are the reflections stored, what can I do to get the near grid reflections to match up to the actual installed texture without reinstalling the whole game again? lol. Thanks. I tried deleting the enhanced water and bashed .esp and reinstalling fresh ones and that didn't work. Link to comment Share on other sites More sharing options...
shinobi2008 Posted December 8, 2011 Share Posted December 8, 2011 So on my most recent game install, I installed Qarls -> RAEVWD -> Enhanced Water, but then tried going back to the reduced lite Qarl's to see if it helped framerate at all, didn't notice much of an improvement, so reinstalled full Qarl's and RAEVWD again. Unfortunately, I must have screwed something up because the water reflections of the main bridge outside of the Imperial city appears correct from a distance (darker version of the bridge from RAEVWD), but flickers the lighter texture in certain spots when you get closer. Where are the reflections stored, what can I do to get the near grid reflections to match up to the actual installed texture without reinstalling the whole game again? lol. Thanks. I tried deleting the enhanced water and bashed .esp and reinstalling fresh ones and that didn't work. Not sure if this would help but did you run TES4LODGen after installing RAEWD? Link to comment Share on other sites More sharing options...
Nitefox98 Posted December 9, 2011 Author Share Posted December 9, 2011 Yeah, I did. I also noticed that water reflections were showing lit up windows during the day, even though the buildings themselves didn't have lit windows. I'm not sure where water reflection info is stored if it's not realtime, but I ended up just going back to a clean install and starting over, lol. Link to comment Share on other sites More sharing options...
Nitefox98 Posted December 10, 2011 Author Share Posted December 10, 2011 Ok, I figured it all out. The flickering reflections under the bridge were just a flaw from vanilla oblivion once you enable static reflections, the sides of the bridge reflect fine if you don't install the RAEVWD bridge textures. Also, RAEVWD only installs lit windows in distant water reflections, since it has to be one or the other. Link to comment Share on other sites More sharing options...
Recommended Posts