lizardnexus Posted December 10, 2016 Share Posted December 10, 2016 (edited) It just started doing this. When the widgets are on I can click on the axis points but my mouse doesn't grab them. I have to click several times on an axis always making sure that the axis' object is also in the click, this is quite unpredictable, but once a single axis is been selected and turned yellow then I can move or rotate the object, but! I can't do so if I am trying to grab the axis I can only manipulate the object if the axis is selected yellow and I perform the manipulation by grabbing the object itself. If the macros are off, I can manipulate the object normally. Resizing by axis is impossible and can only be done by using the 'S' hotkey. Thus, markers can not currently be resized because they are reliant upon the use of individual axis and the 'S' key is a 1:1 ratio scale. My guess is that I used a bad hotkey combination at some point, but otherwise I have no idea what caused this. Edit: Before restarting CK is suggested, this has been constant over about two days now. So more than several restarts have happened. Edited December 10, 2016 by lizardnexus Link to comment Share on other sites More sharing options...
lizardnexus Posted December 10, 2016 Author Share Posted December 10, 2016 Actually, I figured out the problem. I apparently had my mouse double click speed too low. I maxed it out and now I can grab them again. So weird. Link to comment Share on other sites More sharing options...
Recommended Posts