Floor problem

[Linky1]

Hi all,

I have been working on a big project for Oblivion and part of this project adds a few cities.

One of these cities is Hawkhaven, I have re made it into a city.

The problem is, on the CS when I add NPC's to the game and put them at ground level, they are fine.

When I go onto Oblivion and look at them, all of them in the exterior (like in the city, but the exterior) are in the floor slightly.

This doesn't bother me much but it does make some things not work as planned, the floor is basically at the NPC's ankles.

Also (secondary error) the NPC's I place don't start where they are meant to (in the same area as the ankle-floor problem) and are way off mark, which again causes problems and is quite annoying.

 

Thanks in advance :)

 

Linky1

[kingtitan]

Hi all,

I have been working on a big project for Oblivion and part of this project adds a few cities.

One of these cities is Hawkhaven, I have re made it into a city.

The problem is, on the CS when I add NPC's to the game and put them at ground level, they are fine.

When I go onto Oblivion and look at them, all of them in the exterior (like in the city, but the exterior) are in the floor slightly.

This doesn't bother me much but it does make some things not work as planned, the floor is basically at the NPC's ankles.

Also (secondary error) the NPC's I place don't start where they are meant to (in the same area as the ankle-floor problem) and are way off mark, which again causes problems and is quite annoying.

 

Thanks in advance :)

 

Linky1

 

Did you manually drop them onto ground level or use the "f" command? You can also always put them into the CS slightly above ground level. Also, have you by chance pathgridded the area? Make sure path nodes arent buried in the ground, that could also cause you problems.