dcmvu01172 Posted February 4, 2012 Share Posted February 4, 2012 Hey everyone, So I'm working with the Mothership Zeta kit pieces, and I've discovered that the piece "DLC05MZHallSmCurve01" (essentially a curved arc hallway) doesn't seem to like snapping to grid like other pieces. The cell I'm building is essentially using a circle of these (I think it comes 2x curved halls for 1/4 of a circle) with rooms at each of the cardinal directions, linked to these arced pieces. Am I pretty much going to be doomed to manually build all 4 rooms, position them, then manually move the arc pieces off the grid? Link to comment Share on other sites More sharing options...
GrindedStone Posted February 6, 2012 Share Posted February 6, 2012 Snap to reference works sometimes on those odd pieces. Often I use a 1 grid to keep things on the .0000 but some of the pieces are just like that. You can either adjust it manually in the mesh or go to the pain of placing it. 16 32 64 128 grids an you never can tell which if any will work with one piece or the other. Link to comment Share on other sites More sharing options...
Recommended Posts