VulcanTR Posted September 5, 2017 Share Posted September 5, 2017 But it is active. Here is my ini [General]ClearInvalidRegistrations=1EnableDiagnostics=1[Memory]DefaultHeapInitialAllocMB=1024ScrapHeapSizeMB=384[Display]iTintTextureResolution=2048 But still it says memory fix not active and i get ctd's and i cannot check. What should i do? Link to comment Share on other sites More sharing options...
Dusty4life Posted September 6, 2017 Share Posted September 6, 2017 IIRC the scrap heap size should be 256. I had problems with it at some point. I just downloaded the SSME (which is technically redundant as it apparently has been been implemented into SKSE) and it works. Give it a shot. Link to comment Share on other sites More sharing options...
saurusmaximus Posted September 6, 2017 Share Posted September 6, 2017 Try lowering your DefaultHeap to 896. ScrapHeap should be set at 256 and nothing else. Link to comment Share on other sites More sharing options...
wfandrews Posted September 7, 2017 Share Posted September 7, 2017 Where did you install the skse.ini file you created? I have my DefaultHeap at 768 which works for me but this seems to be a personal preference. However the settings should have no effect on whether the ini file is detected by Skyrim or not. Although I would use the settings as suggested that is not your problem. The installation of the file is the only thing I can think of that would cause your problem. Link to comment Share on other sites More sharing options...
Recommended Posts