Jump to content

Editing custom light source via console


motorheadkaze

Recommended Posts

Howdy. Been playing with Vlindrel Hall furniture with the console, adding Dwemer chairs/cabinets, etc. and took on the challenge of adding a candle + light source for that candle (if it matters, believe it was 3611F SolitudeInnCandleDefault) . My question is related to the light source itself.

 

Due to lack of better knowledge, I dealt with placement of the light source by placing my character on top of the chest the candle sits on -- and used TCL command to put myself right where the light would look best. However, I would like to know:

 

1. How the heck do you click on a light source to adjust placement? Won't clicking on it actually end up selecting the wall behind the light source?

 

2. If one wanted to remove that light source, how can this be done? (other than going back to the previous save) Again, I wouldn't want to delete a wall by mistake.

 

Look forward to hearing some good advice.

Link to comment
Share on other sites

Because I enjoy using the console. Also, most of my house edits thus far are surprisingly easy with the console, there's not really any need to get into CK just yet. I plan to play with CK fairly soon so I can do things with shrines or weapons racks, and full on creation from scratch...but not until I stop having fun with the ol' console. Edited by motorheadkaze
Link to comment
Share on other sites

Click on the light source, and use the scroll wheel to change between the target and those between you and it. You can't kill fog, so I use it for getting to the enemies.

 

Mark for Delete is the permanent command, and disable is the temporary one I believe.

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...