Jump to content

Trying to edit custom race


Curious002

Recommended Posts

I downloaded "Elves of Lineage II" and while the graphics are very beautiful, I found the settings for the races themselves are more than only a little disappointing.

 

So I went forward and changed the attributes and skills to something that was much closer to my own ideas (and to what elves where in L2, in my opinion - matriarchal, i.e. women get more of willpower/personality/intelligence, and the skills should be different too, etc).

 

However, I ran into 2 problems:

 

- When I load both my fixup module and the original module, I get warning messages that both modules contain the same races (unsurprisingly) - and end up with 2 instances of these new races in the corresponding dialogue !

 

- I cannot edit the special abilities at all - the only option I get there is "delete".

 

Anyone has an idea what to do ?

Link to comment
Share on other sites

I downloaded "Elves of Lineage II" and while the graphics are very beautiful, I found the settings for the races themselves are more than only a little disappointing.

 

So I went forward and changed the attributes and skills to something that was much closer to my own ideas (and to what elves where in L2, in my opinion - matriarchal, i.e. women get more of willpower/personality/intelligence, and the skills should be different too, etc).

 

However, I ran into 2 problems:

 

- When I load both my fixup module and the original module, I get warning messages that both modules contain the same races (unsurprisingly) - and end up with 2 instances of these new races in the corresponding dialogue !

 

- I cannot edit the special abilities at all - the only option I get there is "delete".

 

Anyone has an idea what to do ?

 

Are you using the Construction Set to edit them?

To begin, I would say you only need to load one .ESP (the "home improved" one).

 

I don't have the module installed, so I'm making an educated guess here: first off, I suppose you switched on "Make Active" for your editing purposes. Check under the race menu again, it might just be a tricky setup.

 

Also, if you're running under Vista look up the usual suspects: UAC, permissions, and so on.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...