flameshiva Posted February 23, 2020 Share Posted February 23, 2020 (edited) As the title sais everytime I snap tiles together they overlap even a little and then there is flickering. Using snap to grid and snap to angle and also I have tried lowering the snap to grid but thats not doing much for me. I spent hours being careful which turned out didn't help too. To think I am only trying to make a small room but it's very frustrating when interior tiles are very difficult to snap together adequately. Any suggestions ? :sad: Update: After lowering the snap settings to obscenely low numbers I got something to an acceptable standard. Not great, just acceptable. At this stage I don't know if it was just Luck. Maybe it's the tiles I am using (office) but anyway snapping has been more difficult than it should be. Even a very slight overlapse causes flickering and slight gaps cause black lines. So i am still looking for ideas or perhaps suggestions on something that I may have overlooked. Thanks. Edited February 24, 2020 by flameshiva Link to comment Share on other sites More sharing options...
JW1 Posted February 26, 2020 Share Posted February 26, 2020 What do you consider "obscenely small"? The office pieces should work fine with the grid set to 16; for certain pieces 8 may be necessary. Always use multiples of 2. Link to comment Share on other sites More sharing options...
Recommended Posts