My first room for Fallout and a big problem! ;(

[oOBlazeOo]

aloha.

as a total beginner i started on creating my own bunker for fallout. i have finished my work on the room so far. i also have a door in the wasteland connected to the roomdoor.teleporters are there too. (i haven't done anything with navmishes yet,is this important?) well, my problem is: i load the mod and go to the place in the wasteland and there is no freakin door!! -.- i look again in geck and there it is... it drives me mad cause i can't figure out how to fix it :wallbash: i created my room just like the one in geck tutorial...

help is very welcome

[Sajus]

#1 make sure the mod is loaded

 

#2 if your door is hanging in mid air you will have

to be infront of it to see it

 

Hope that helps

[oOBlazeOo]

well...

the mod is loaded,at least i marked it in the file-menu before starting to play.

my problem is that the placed things in the wasteland just don't display! i placed big stairs and a door and non of them is there ;(

[Sajus]

If i could get your .esm file for your mod i could take a look at it for you

[oOBlazeOo]

you mean the .esp file no? i can send it to you via email if you like.

[Sajus]

ok, there should be a link on my profile

[Sajus]

worked fine for me... make sure you dont have any conflicting mods. If you dont have any mods try another one.

[oOBlazeOo]

so could you enter the room at the memorial??

[ruhrmetall]

I have a similar problem with changes in GECK not affecting the game. Only if I start a new game or load a savegame in which i was not at the edited place before, i see the state like in GECK. I guess some things are only set at initialisation time. Or is there a trick for updating the place in game?

[Sajus]

Yep, i got into your door on top between the statues.