Objects don't line up... help.

[sumoftwosins]

When I am designing interiors I sometimes run into a problem when nothing will line up correctly. Everything will be fine and snapping to full values on X,Y,Z.... Then out of no where things start shifting to decimal values. If that doesn't make sense, here is an example.

 

I place wall and hallway sections at the Z 6000.00. X & Y are respective to their location, but on a full value like 2350.00 and not 2350.235

Then out of no where, everything that I drag out for... say the Z is 5967.346 or something. I can not reset the object to 6000.00. When I do, it will go their for a moment, but if I click on it again, it drops to that 5999.243 value. If I exit and open the GECK again, everything is back to normal. Its annoying and wasting a lot of time.

 

So is this a glitch or is there a setting that is getting changed and I don't know it?

[Skree000]

make sure you arent accidentally turning on and off snaps. I think theres a shortcut for that, if you disable snapping, your stuff wont line up anymore.

[cj577]

When I am designing interiors I sometimes run into a problem when nothing will line up correctly. Everything will be fine and snapping to full values on X,Y,Z.... Then out of no where things start shifting to decimal values. If that doesn't make sense, here is an example.

 

I place wall and hallway sections at the Z 6000.00. X & Y are respective to their location, but on a full value like 2350.00 and not 2350.235

Then out of no where, everything that I drag out for... say the Z is 5967.346 or something. I can not reset the object to 6000.00. When I do, it will go their for a moment, but if I click on it again, it drops to that 5999.243 value. If I exit and open the GECK again, everything is back to normal. Its annoying and wasting a lot of time.

 

So is this a glitch or is there a setting that is getting changed and I don't know it?

 

 

Also adjust your settings like 32 or 64 or 129 etc that plays a big role, also make sure your using the same kit pieces if you use say two different ones your going to have problems with things snapping together correctly!