Jump to content

[LE] NPCs will not perform attacks?


Recommended Posts

I just started making my absolute first dungeon in Creation Kit, so I still have a lot of learning curves.

 

I seemed to have ran into an issue with a couple friendly NPCs I made. They are store vendors that are Essential and are in a faction with me, when they go to attack enemies, they will block and engage in combat, but they wont actually dish out any attacks. I set them to aggressive and foolhardy with the default combat style, but I can't seem to get them actually swing their weapons.

 

I do have navmeshes, so they will approach enemies, they just wont attack them.

 

Is there something I should know? I checked everywhere and I couldn't find anything that is specifically this.

Link to comment
Share on other sites

  • 2 years later...

I found the issue, for some reason, their attack data was set to some different creature. I just set the attack data to none, and hit ok, that reset the attack data to the default one for that race.

Thanks for posting your solution. Had the same problem and for the life of me could not find the problem until now.

Link to comment
Share on other sites

  • 1 year later...

I found the issue, for some reason, their attack data was set to some different creature. I just set the attack data to none, and hit ok, that reset the attack data to the default one for that race.

I have the same problem but I did this and everything but it didn't work is there anything else casing the problem... I need to figure this out as soon as possible cause it ruining my mods

Edited by HighlordVaakko
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...