Jump to content

Assassin's Creed 2 Trailer


Halororor

Recommended Posts

Just saw this on another forum. Sadly, I also don't have a webcam, so I can't figure it out either.

 

Guys there is like this strange puzzle on the main site, i clicked on this circular thing at the end of the trailer and it lead me to my adobe reader and then i zoomed at the fine print at the bottom and there are instructions here,ill list them.

 

1:Print Artifact symbol[done]

2:Locate well lit work area[done]

3:Activate local webcam[not done][dont heave webcam]

4:Initiate Virtual Interface[not done]

5:Determine Matching Partition[Not done]

 

anyone here have a webcam?

Link to comment
Share on other sites

Well that trailer hasn't shown very much.

 

Information you can get from the trailer:

 

A flying machine (a wing attached to an arm)

A futuristic looking dagger?

 

Thats about it for me.

Link to comment
Share on other sites

Just saw this on another forum. Sadly, I also don't have a webcam, so I can't figure it out either.

 

Guys there is like this strange puzzle on the main site, i clicked on this circular thing at the end of the trailer and it lead me to my adobe reader and then i zoomed at the fine print at the bottom and there are instructions here,ill list them.

 

1:Print Artifact symbol[done]

2:Locate well lit work area[done]

3:Activate local webcam[not done][dont heave webcam]

4:Initiate Virtual Interface[not done]

5:Determine Matching Partition[Not done]

 

anyone here have a webcam?

 

Perhaps you have to hold up the printed symbol to the webcam after going to the AC2 site. I can't figure out the "determine matching partition".

Link to comment
Share on other sites

Actually it came built in with my dads new iMac, no instructions or anything but I haven't really tried it out.

 

I'll attempt to do this code thing though.

Link to comment
Share on other sites

THIS IS AWESOME!!!

 

I PRINTED OFF THE SHEET, WENT ON TO A WEBCAM, ON SITE AND PUT THE PICTURE UP TO THE WEBCAM.

 

A Circle appeared around the sheet I printed, with a sign that said "validating"

 

It validated the sign, and up appeared a 3D replica of an arm with the wrist-blade on it, the arm followed the sign on the sheet around and I could turn the arm as I turned the sheet. It was pretty cool, I could view most sides of the arm as I turned the sheet around.

 

Also its of note that the arm had 5 fingers.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...