Skidgeroonie Posted December 15 Share Posted December 15 Hey all. Having a funky issue and thought I'd throw it out to you all. In a custom cell, the floors and walls seem to disappear and pop back in when looking around. Here's a little handy-dandy gif to explain what I'm on about. I've had a look around but just can't figure out what's causing it. I have another area similar to this, with all the same cell settings, and that doesn't have this issue. I don't have the GECK red ring to say the engine is dying under it's own weight. If anyone has any ideas, I'd really appreciate it. Link to comment Share on other sites More sharing options...
JimboUK Posted December 15 Share Posted December 15 Did you duplicate a cell and then edit it? if so I wonder if there are any multibounds or some such that have been copied over with it. 1 Link to comment Share on other sites More sharing options...
Skidgeroonie Posted December 15 Author Share Posted December 15 Ah well wouldn't you know it, you were bang on. I was struggling to find any multibound markers that would be causing my grief, but after a little more messing around I found under VIEW > SHOW/HIDE WINDOW, there was a checkbox for Portals and Rooms. I ticked that, and the little blue painmakers showed up in the render window. I've deleted them now and everything is working as intended. Thank you Jimbo! So for any googlers who are having the same issue as I was, load your cell, in the toolbar at the top go to View, then Show/Hide Window, make sure Portals and Rooms is ticked and check for any boxes that look like what Jimbo has posted above. Link to comment Share on other sites More sharing options...
Recommended Posts