BossDweebe Posted July 23, 2009 Share Posted July 23, 2009 I have made a small grotto with waterfalls, but can't work outhow to manipulate the water plane. I have moved a large section up anddown, but don't really understand what I did. I also need to know howto select a small section so I don't flood the whole area. Can anyone help a confused old man ? Link to comment Share on other sites More sharing options...
AncientSpaceAeon Posted July 23, 2009 Share Posted July 23, 2009 I think you must flood the whole area, other wise it won't work (maybe). Link to comment Share on other sites More sharing options...
MikeHibs Posted July 23, 2009 Share Posted July 23, 2009 Well according to this article http://cs.elderscrolls.com/constwiki/index..._exterior_cells You can't raise the water without flooding the hole area.But, it does mention some water meshes that you can use. Link to comment Share on other sites More sharing options...
BossDweebe Posted July 25, 2009 Author Share Posted July 25, 2009 OK - I finally got it. I was not realising that the terrain map is more than one (or two) cell.So while the water does flood a whole cell, it is still a somewhat small space. The mod I was looking at (without paying attention to the cell numberchanging) were cleverly laid out with a waterfall and a small pool startingat the bottom corner of one cell and crossing, while dropping diagonally, into another cell. After a short run it turns left into the adjacent cell and drops for athird time. Sneaky... Three levels over a short area. Link to comment Share on other sites More sharing options...
Recommended Posts