MBSNgaming Posted October 13, 2016 Share Posted October 13, 2016 I'm a new modder and I'm just starting to experiment with the creation kit for fun and to see what I am capable of. I want to be able to access data in the creation kit from Skyrim, Dragonborn, and Dawnguard, but I cannot get all three working simultaneously. When I try I get the message "multiple master files selected for load. Load operation aborted". I should probably mention that I can get Skyrim + Dragonborn to load up fine, same with Skyrim + Dawnguard, but when I try all 3 I get the error message. I've been scouring the internet in search of a solution to my problem, and everywhere pretty much says In SkyrimEditor.ini (Skyrim folder) under [General] set bAllowMultipleMasterLoads=1 However, when I enter SkyrimEditor in notepad bAllowMultipleMasterLoads is nowhere to be found. I ran searches, read each line of the general section individually and still could not find it. Did something change since these solutions were posted online? How can I fix this? P.S. I've already added the DLCs under sResourceArchiveList2 so that's probably not the problem. Thanks! Link to comment Share on other sites More sharing options...
IsharaMeradin Posted October 13, 2016 Share Posted October 13, 2016 By default that line is not present in the ini file. You have to add it. Link to comment Share on other sites More sharing options...
MBSNgaming Posted October 13, 2016 Author Share Posted October 13, 2016 Okay, thanks a bunch! Link to comment Share on other sites More sharing options...
thumbincubation Posted October 13, 2016 Share Posted October 13, 2016 I've been under the impression that you would need to add both of these lines to the general tab. bAllowMultipleMasterFiles=1bAllowMultipleMasterLoads=1 Am I able to get away with only adding the Loads one? Link to comment Share on other sites More sharing options...
IsharaMeradin Posted October 13, 2016 Share Posted October 13, 2016 You only need: bAllowMultipleMasterLoads=1The other is non-existent as far as I know. Link to comment Share on other sites More sharing options...
thumbincubation Posted October 17, 2016 Share Posted October 17, 2016 Ah, ok. Thank you. Hard to pin down what is original to a procedure, after it's gone around the proverbial block a few times. Link to comment Share on other sites More sharing options...
Recommended Posts