H4RDC0R3V1B3Z Posted May 16, 2017 Share Posted May 16, 2017 If this has already been done, i can't find it so if anybody has it bookmarked, I'd really appreciate the link. Thanks! So, the request. The pressure plates annoy me for two main reasons: 1) They're too small.2) The wire connection point pokes out quite a bit if you clip the plate into the floor slightly so it's flush but still works. This is why I never use the blasted things, although they would make my life that little bit easier. To solve these issues, I have these thoughts: The power connection point needs moving or making much smaller. Ideally, it should be either on the side (or bottom, really) of the plate. Some various sizes, say a 2x1 (that's one wall length and a half-wall width). 2x2, 4x1, etc. I know you can snap the vanilla plates together but each one still requires a separate connection. And yes, I know you can just connect wires from one to the other. You're missing the point lol. Please say this has already been done or that somebody is willing to take this (relatively-minor?) task to hand? Link to comment Share on other sites More sharing options...
Recommended Posts