Jump to content

dunmer stronghold


Camonna

Recommended Posts

I was exploring in the upper azuras coast region to the east and I found a dunmer stronghold.

I cannot remember its name but there was a high elf called a "worshipper"

 

And I saw a door with candles around it and a note being held up by a steel dagger,I read the note and it said it was enchanted or somethin so I went in and killed a few "worshippers"and then looked for the exit for around 20 minutes!!Then I checked my little map and there was no door! :huh: :huh:

 

whats going on?

Link to comment
Share on other sites

There is a door. After you have reached the altar to Molag Bal, take the passage to the right. The other two lead you in a circle. FOllow that passage until the tunnel branches. Take the passage that leads to the right again. There will be a large cavern with a few Worshippers, and an exit door. But do NOT kill Qorwynn- he is the Master trainer of Enchant, even though he does attack.

 

And the place you are in is Indoranyon.

Link to comment
Share on other sites

The door, as I mentioned before, is behind Qorwynn. It is surrounded by some mist and a half-circle of candles.

I quote myself:

Take the passage that leads to the right again. There will be a large cavern with a few Worshippers, and an exit door.
Link to comment
Share on other sites

You didn't enter through a door. The door is supposed to be "enchanted," from the note on the door, and it takes you to that cave instead of the interior of the stronghold. There is no door behind you when you first come into the cave. You come in amid a circle of candles- no door. You leave via the door I mentioned. And that door acts like the door that put you inside the stronghold in the first place. You can;t leave via the same door you entered with, because you didn't really use the door!
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...