darkeradicator36 Posted September 3, 2018 Share Posted September 3, 2018 I'm making a personal mod and I've run into a problem where a door i placed to enter the world will not move in-game after i move it in the CSCS position: https://imgur.com/a/zbxNCj6In-game position: https://imgur.com/a/wR1uZS2 Link to comment Share on other sites More sharing options...
DrakeTheDragon Posted September 4, 2018 Share Posted September 4, 2018 Did you visit the place before inside your game and saved, while the door was at the old place? The locations of doors are said to be stored inside your savegames, thus many mods changing lots of doors (like Better Cities) come with scripts to move them in game. I don't know if a cell reset will help with this, but it can't hurt going away from the cell far enough and waiting for 3 days (or how much your cell reset count is configured to) to see if it helps. If it doesn't though, I'm afraid you'll have to revert to a savegame from before you visited the cell with the door at the old location. Perhaps a clean-save, that is disabling your ESP, loading, saving, then enabling it again, will also do the trick, but I'm not sure it works with doors. Link to comment Share on other sites More sharing options...
darkeradicator36 Posted September 4, 2018 Author Share Posted September 4, 2018 you know whatthat might just be iti had no idea doors worked that way and this whole time i have been saving in-game in the area that im moddingi'll do what you said and let you know if it workedthanks! Link to comment Share on other sites More sharing options...
darkeradicator36 Posted September 9, 2018 Author Share Posted September 9, 2018 it doesn't seem like what you suggested solved the problemi played a few hours and never returned to the mod location and saved the construction set a few times, and when i went back, the door was still in the wrong position Link to comment Share on other sites More sharing options...
DrakeTheDragon Posted September 9, 2018 Share Posted September 9, 2018 Then door positions are not affected by cell resets. I was afraid of as much.(Not sure what you mean by "saved the construction set", as that's nothing to do with it, though.) What about the clean-save suggestion? Did that help at least? Link to comment Share on other sites More sharing options...
Guinefort1 Posted October 31, 2018 Share Posted October 31, 2018 I've found that you have to do the following to change a door position: - disable the door as a permanent reference- move the door mesh to the desired location- reset the door as a permanent reference and re-link the door to its partner on the other side Link to comment Share on other sites More sharing options...
Recommended Posts