Aterr Posted February 24, 2016 Share Posted February 24, 2016 I've been trying unsuccessfully to use the console to place a workbench... the command I have is "player.placeatme c1aeb" It does place the workbench like it should, but when I attempt to use it, I get a message that I need to clear enemies from the area... there are no enemies in the area. I have tried "killall" commands and still get the same message... I used 'tgm" and a MIRV for like 10 minutes to see if there was anything that could be remotely called an enemy... nothing. Anyone have any ideas, or suggestions where I might be going wrong? Link to comment Share on other sites More sharing options...
kevkiev Posted February 25, 2016 Share Posted February 25, 2016 I ran into the "you can't use this while in combat" thing a couple times recently, although each time I couldn't find an enemy anywhere. I fixed it both times by simply fast traveling to the location I was at. Maybe give that a shot? Link to comment Share on other sites More sharing options...
Aterr Posted February 25, 2016 Author Share Posted February 25, 2016 I ran into the "you can't use this while in combat" thing a couple times recently, although each time I couldn't find an enemy anywhere. I fixed it both times by simply fast traveling to the location I was at. Maybe give that a shot?I'll give that a shot, I've already nuked the tar out of the place :nuke: Link to comment Share on other sites More sharing options...
Aterr Posted February 28, 2016 Author Share Posted February 28, 2016 I ran into the "you can't use this while in combat" thing a couple times recently, although each time I couldn't find an enemy anywhere. I fixed it both times by simply fast traveling to the location I was at. Maybe give that a shot?I'll give that a shot, I've already nuked the tar out of the place :nuke: No, that did not work either. I've seen the videos on youtube where a guy just ran up, hit console, placed a Workstation, closed the console and started it right up, hit the console again, ran a bat file of materials, then was off doing his build. I still don't understand why the Clear Enemies thing is there. Link to comment Share on other sites More sharing options...
Aterr Posted March 9, 2016 Author Share Posted March 9, 2016 Bump! Anyone know of a way to clear the Combat flag? Really, like I screwed up a bridge and get a complete walk-through on how to fix it (Many thanks for that one!!!) Link to comment Share on other sites More sharing options...
Descivii Posted March 10, 2016 Share Posted March 10, 2016 tgm - toggle God mode; try that Link to comment Share on other sites More sharing options...
Recommended Posts