jtcornpone Posted October 11, 2018 Share Posted October 11, 2018 I just installed Vortex, Installation and movement of Nexus mods went fine, but when I went to load my game, none of my Bethnet mods were enabled. I enabled them, but when the game reloaded, the mods had been disabled again. Is this aVortex problem, or something else? Link to comment Share on other sites More sharing options...
Pickysaurus Posted October 11, 2018 Share Posted October 11, 2018 Mods install by Bethesda.net should be visible in Vortex on the plugins tab. Something may be altering your load order between switch applications but I am unsure what exactly it would be. Are you sure the Beth.net mods are "enabled" in the Vortex plugins section? Link to comment Share on other sites More sharing options...
jtcornpone Posted October 11, 2018 Author Share Posted October 11, 2018 I'll have to check on that. Thanks. Link to comment Share on other sites More sharing options...
jtcornpone Posted October 11, 2018 Author Share Posted October 11, 2018 I don't see them in the Plugins or Mods tabs, at least not before I've started the game and re-enabled them on Bethnet. Link to comment Share on other sites More sharing options...
Pickysaurus Posted October 11, 2018 Share Posted October 11, 2018 I don't see them in the Plugins or Mods tabs, at least not before I've started the game and re-enabled them on Bethnet. That would be correct, disabling them on Bethesda.net removes them from your mods folder as far as I know. Link to comment Share on other sites More sharing options...
jtcornpone Posted October 11, 2018 Author Share Posted October 11, 2018 That's the problem. I re-enable them on Bethnet, the game reloads the save files, but when I go to load my game, the mods have been disabled again. Link to comment Share on other sites More sharing options...
Pickysaurus Posted October 11, 2018 Share Posted October 11, 2018 I've just tried to replicate the issue and I can't see any problems. Both Bethesda.net and Vortex edit Plugins.txt so editing with Vortex or built-in load order should preserve changes in both cases. Could you possibly provide some screenshots of the steps you're taking if the issue keeps happening? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.