JimmyRJump Posted February 25, 2020 Share Posted February 25, 2020 Was wondering how to go about things to move the location of a map marker in SSE. It's the marker for Fort Dawnguard, which to my liking, is dropping you off way too far from the actual fort. So, I'd like to make it so that you end up at the fort itself and not halfway between the valley entrance and the fort. Link to comment Share on other sites More sharing options...
speedynl Posted February 25, 2020 Share Posted February 25, 2020 (edited) find the (red)heading marker thats belong to the mapmarker, its under 1 of the mapmarker tabs, move the heading marker to where you want to land after fast travelmoving the mapmarker itself will do nothing or the yellow line will show you where the heading marker is Edited February 25, 2020 by speedynl Link to comment Share on other sites More sharing options...
JimmyRJump Posted February 25, 2020 Author Share Posted February 25, 2020 find the (red)heading marker thats belong to the mapmarker, its under 1 of the mapmarker tabs, move the heading marker to where you want to land after fast travelmoving the mapmarker itself will do nothing or the yellow line will show you where the heading marker isGe zait gai bedankt, kameroet (Brussels accent) ;)I'll have a look at it and see what happens. Link to comment Share on other sites More sharing options...
speedynl Posted February 25, 2020 Share Posted February 25, 2020 mm dawnguard, if i remember right the fasttravel point change when you join them, at the start you end up hafway the valley, but later on closer to the castle maybe there are 2 landing points, but connected(scripted) to the quest if so you have to check if 1 is disable by default and the other not, change them then(swap)never did much with se(ck) but it prolly works like fo4 Link to comment Share on other sites More sharing options...
anjenthedog Posted February 25, 2020 Share Posted February 25, 2020 mm dawnguard, if i remember right the fasttravel point change when you join them, at the start you end up hafway the valley, but later on closer to the castle maybe there are 2 landing points, but connected(scripted) to the quest if so you have to check if 1 is disable by default and the other not, change them then(swap)never did much with se(ck) but it prolly works like fo4 Same for Riverwood and afaik a few other places. When I first started fast traveling, when I chose Riverwood, it'd dump me at the Whiterun side gate. At some point that changed and now it always drops me at the other end. Whiterun too (I think). I'm dropped off just inside the city gate, but I'm almost sure that when I first started fast-traveling to whiterun it'd drop me off outside the city gate. Link to comment Share on other sites More sharing options...
Evangela Posted February 26, 2020 Share Posted February 26, 2020 It will not always be an XmarkerHeading(in this case it is), it could be a COCMarkerHeading too. Link to comment Share on other sites More sharing options...
Recommended Posts