Jump to content

Red Rocket Not a settlement


endersblade

Recommended Posts

So this is strange. I recently started up a new game. Early on, I took over Red Rocket, but on the map it said Red Rocket Truck Stop (Cleared). Didn't think anything of it. I proceeded to build and build and build. Eventually settlers showed up. I could assign them to food, defense, etc.

 

Fast forward about 15 hours of gameplay, I decide to set up trade routes between towns. I go to Sanctuary, pick a settler, pull up the list, and Red Rocket isn't on it. I went to Red Rocket, and was able to send a settler to Sanctuary to get the trade going. But no matter what I did from other places, I couldn't pick Red Rocket. It also doesn't show up on the map when you change it to show trade routes - there is a line to a blank area where RR should be. It isn't in my workshop list, either, and still shows as (Cleared) on the map.

 

I have done everything I can think of. I used the pv command to make sure I was the owner, I tried killing everyone, I tried scrapping everything I did, I even tried deleting and re-adding the workshop. (I had to reload an earlier save after that, the workshop stopped working completely after doing that.) RR is lost to me. The people aren't hostile at all, but I can't trade them items, and I can't set trade caravans TO RR, just FROM RR.

 

Is there any way to get RR back to the way it should be? I have no mods at all that should affect RR, I've been using the same exact mod list for several playthroughs.

Link to comment
Share on other sites

I just said I wasn't running any...

 

None of my mods affect settlements except for scrap everything and place anywhere. I have no mods that affect factions, and besides those two, nothing that affects cells. And out of all of the settlements I have, it is ONLY RR that is doing this. It hasn't actually been a full settlement since I first started working on it. And again, I've done at least 2 other complete runs on this same exactly identical mod setup - nothing has changed at all. I've checked the forums for all of my mods, nobody else is having this issue.

 

Now, instead of trying to point the finger at mods, which I know it isn't because a quick google-fu has shown that this has happened on PS4 before, does anyone know of a fix? I'm too far in to just start over, though I may start a new game to see if the problem happens again. Granted, RR isn't important enough for me to warrant scrapping the 30+ hours I've put into this game so far, so if I can't get a fix, I'll just deal with it.

Link to comment
Share on other sites

If i understand your right, you can assign a trade rout from RR to anywhere, but not vice versa. So its annoying but not really a problem, because you have your trade route. As far as i remember it doesnt matter from where you start a route.

I would not waste time to fix something that dont really count.

Link to comment
Share on other sites

I just said I wasn't running any...

Â

None of my mods affect settlements except for scrap everything and place anywhere. Â I have no mods that affect factions, and besides those two, nothing that affects cells. Â And out of all of the settlements I have, it is ONLY RR that is doing this. Â It hasn't actually been a full settlement since I first started working on it. Â And again, I've done at least 2 other complete runs on this same exactly identical mod setup - nothing has changed at all. Â I've checked the forums for all of my mods, nobody else is having this issue.

Â

Now, instead of trying to point the finger at mods, which I know it isn't because a quick google-fu has shown that this has happened on PS4 before, does anyone know of a fix? Â I'm too far in to just start over, though I may start a new game to see if the problem happens again. Â Granted, RR isn't important enough for me to warrant scrapping the 30+ hours I've put into this game so far, so if I can't get a fix, I'll just deal with it.

I installed scrap everything and place anywhere a few months ago and they never worked so I uninstalled them. Have you tried disabling one or both to see whether the problem is resolved ?

Link to comment
Share on other sites

 

I installed scrap everything and place anywhere a few months ago and they never worked so I uninstalled them. Have you tried disabling one or both to see whether the problem is resolved ?

 

LOTS of people use both of those mods with no issues whatsoever. However they do require slightly more effort than simply hitting the install button. You do actually have to read and follow the directions for those to work.

Link to comment
Share on other sites

endersblade

I realize you've been using the same mod list successfully for multiple play throughs but it's always possible a game update or a mod update has caused a new incompatibility that you didn't experience before. Posting your mod list would be really helpful. :) Also are you running the latest game version?

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...