grandpauj1 Posted February 18, 2017 Share Posted February 18, 2017 Hi all, I'm sure this is probably on this forum but not really sure how to describe it other than it looks like sh**. I haven't played FO4 awhile and went to play it today. I can not get over 30 FPS (my monitor is a 144) and it like I said looks horrible. I am also playing Skyrim locked at 60 FPS and GTA5 at around 90 FPS and they are both working and looking fine. I have not gotten in to the .Ini files as I don't want to screw stuff up. Any ideas??MoBo-Asus z170-aCPU- i7-6700kGPU GTX 960 SC x2 SliRAM- 32 Gb DDR4 2400 Link to comment Share on other sites More sharing options...
Fkemman11 Posted February 18, 2017 Share Posted February 18, 2017 Try this ;http://www.nexusmods...t4/mods/22053/? As for your fps your could try optimized textures or Shadow Boost. Link to comment Share on other sites More sharing options...
LobbyUP Posted February 18, 2017 Share Posted February 18, 2017 check your nivida control panel and make sure its not set to adapted? you can use nividia inspector to set max framrate and turn off vsync. maybe a sli problem? maybe ini? i would recommend using nividia inspector. Link to comment Share on other sites More sharing options...
Ondrea Posted February 18, 2017 Share Posted February 18, 2017 Make sure your screen refresh rate isn't at 60 Hertz. I had mine set that way to lock Skyrim at 60 fps, but it locked FO4 at 30 fps. The latest patch caused that brightness bug for me. Disabling god rays and using a darker ENB/ReShade resolved most of the issues for me. Because the god rays keep turning back on, I added sStartingConsoleCommand=gr off under General in my fallout4.ini to it turns off when I log in. Link to comment Share on other sites More sharing options...
grandpauj1 Posted February 18, 2017 Author Share Posted February 18, 2017 Thanks for the reply's, I have been messing with a few things this morning. I think what is the most puzzling is that I have had this game from day one and the game has always played fine. Any how I got the FPS at 30 thing fixed. I went to NVidia control panel and turned "triple buffering" on, set "maximum pre-rendered frames" to 1 and turned "Vertical sync" on. Don't recall where I seen this but it worked. Also another thing I did notice is the load screen looks great (not sure if that matters but...) it's just in game. I did travel to a few places to see if it was different but it is the same everywhere. I tried it with the SLI disabled and enabled, on ultra high al the way down to low. I turned down the brightness of the monitor from 75 to 50 to 25, nope. I even messed with the contrast. Turned "Godrays" off (it was on) and didn't help )o: My refresh rate is set to 144. I even set my CPU back to 4.0GHz, had it set at 4.5. @ Fkemman11, I could not get the link to work. and @ LobbyUP not sure what you mean by "Adapted" I looked in the control panel and did not see it, not saying it's not there, just I didn't see it. Will keep plugging away at it till I get it fixed, love the game so would love to get it fixed . Thanks again for the help and any future help. Link to comment Share on other sites More sharing options...
Fkemman11 Posted February 18, 2017 Share Posted February 18, 2017 Try console command teofis. Someone else said it is a post processing effect bug. Here is the link (fixed); http://www.nexusmods.com/fallout4/mods/22053/?Also you can use ENBoost to cap fps and help performance. :smile: Link to comment Share on other sites More sharing options...
bill8872 Posted February 18, 2017 Share Posted February 18, 2017 (edited) I was using the same video card as you until yesterday. You don't list the vram, so I will assume it has 2gig. The game runs between 3gig, and 4gig of vram depending on mods, and location. Bethesda recommends a card with 4gig vram. I could never get SLI to work correctly with a few of my mods, and have read Bethesda's game don't really support it. I caved in and upgraded my video card to the 1070 with 8gigs of vram. World of difference after doing so. Edited February 18, 2017 by bill8872 Link to comment Share on other sites More sharing options...
grandpauj1 Posted February 19, 2017 Author Share Posted February 19, 2017 @ Fkemman11 I tried the command "teofis" and as far as the brightness problem goes it worked fricken awesome. One down fall is it also has the same effect as the command "tm" I have no compass, no crosshair, HP bar... nothing. I have Riva tuner for the FPS display and that's the only thing left. Will try the mod (thanks for fixing it) tomorrow.@ bill8872, they are both 4gb cards. And as far as getting the SLI working, I went to SLI in June and have had no problem with it until now. I have played FO4, FONV and Skyrim all Bethesda games with no issues. I still play Skyrim (probably the best game ever made IMO) on a daily basis and it loves the s#*! out of SLI. I play FONV on occasion, also with no issue. I did look at graphics cards while walking thru BestBuy the other day and gave it some real serious thought but.........not in the budget right now )o:. Maybe that would be a good way to blow my tax return. Again thanks for the help, you guys rock Link to comment Share on other sites More sharing options...
SharraShimada Posted February 19, 2017 Share Posted February 19, 2017 (edited) Wrong post. sorry. Edited February 19, 2017 by SharraShimada Link to comment Share on other sites More sharing options...
grandpauj1 Posted February 19, 2017 Author Share Posted February 19, 2017 Well I got it (sort of) playable anyhow. My screen on the Pip boy is still looking shi**y but the rest looks a lot better. I used the "Brightness Bug Fix" (link above) and it seems to be doing good. I did some fast traveling and seems good everywhere. Playing @ 70 FPS on ultra. Any clues on the PipBoy? Thanks a bunch, you guys are awesome. Link to comment Share on other sites More sharing options...
Recommended Posts