Jump to content

I'm extremely sad, cause i screwed up one certain quest...


ZeitlosIchZeitlos

Recommended Posts

So i killed Machete Mike.

Yes, i did it cause 3000 caps is 3000 caps. But i didn't know, that it will disable all other Mariner quests! Now i consider my Far Harbour quest list as not fully approved by myself, so i ask for your help, dear community.

How can i restart Hull Breach quest? Is there any possibility to reenable it, or to start others (like Hull Breach 2 and 3)? I tried to use console command "resetquest", but Mariner just get stuck saying one phrase "The Hull took a few bad hits"... And save editor doesn't work too!

 

A do use mods, by the way. My last save is 20 hours of gameplay before my present condition. I pray for your wisdom, people! Many thanks in advance!

P.S. Sorry, if my English is bad sometimes.

Link to comment
Share on other sites

Maybe "Recycleactor" helps

The OP would want to run from the console command line, 'recycleactor' followed by 'resurrect'. Recycleactor does not work on all NPC's. This is all covered on the NPC Manipulation section of the Fallout 4 Console Commands page. Fallout 4 console commands

 

Also, you cannot restart quests from using console commands. Only from previous saves.

Link to comment
Share on other sites

You can restart any quest at any given time through the console.

 

The first Hull Breach quest has XX00a990 as i.d., with the "xx" being the index number of Far Harbor (Coast DLC) in your load order. That number should be 03. Reload your game and open the console and type setstage 0300a990 100 and hit enter. Close the console and you can redo the first quest of the three Hull Breaches.

 

Resurrecting a dead NPC who was needed for a quest won't change anything. The moment you killed that NPC he is dead for the game and everyone involved won't change their knowledge of the NPC dying after resurrecting him/her.

 

You can also do it the other way round and finish the two Hull Breach quests you can no longer get by using the same command but with 0300aec4 for quest two and 0302039a for quest three with both times '400' at the end instead of '100'.

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...